GHT 502 IVR
| Main Menu | "Enter Menu Option" | Press “*” for the next menu option Press “#” to return to the main menu Enter 01-05, 07,10, 12-17,47 or 99 menu options |
| *** | Enter IVR | |
| 01 | DHCP Mode Static IP Mode |
Press “9” to toggle the selection If using “Static IP Mode”, configure the IP address information using menus 02 to 05. |
| 02 | “IP Address “ + IP address | The current WAN IP address is announced If using “Static IP Mode”, enter 12 digit new IP address. |
| 03 | “Subnet “ + IP address | Same as menu 02 |
| 04 | “Gateway “ + IP address | Same as menu 02 |
| 05 | “DNS Server “ + IP address | Same as menu 02 |
| 07 | Preferred Vocoder | Press “9” to move to the next selection in the list: • PCM U • PCM A • iLBC • G-726 • G-723 |
| 10 | “MAC Address” | Announces the Mac address of the unit. |
| 12 | WAN Port Web Access | Press “9” to toggle between enable / disable |
| 13 | Firmware Server IP Address | Announces current Firmware Server IP address. Enter 12 digit new IP address. |
| 14 | Configuration Server IP Address | Announces current Config Server Path IP address. Enter 12 digit new IP address. |
| 15 | Upgrade Protocol | Upgrade protocol for firmware and configuration update. Press “9” to toggle between TFTP / HTTP |
| 16 | Firmware Version | Firmware version information |
| 17 | Firmware Upgrade | Firmware upgrade mode. Press “9” to toggle among the following three options: - always check - check when pre/suffix changes - never upgrade |
| 47 | “Direct IP Calling” | Enter the target IP address to make a direct IP call, after dial tone. |
| 99 | “RESET” | Press “9” to reboot the device Enter MAC address to restore factory default setting |
| *Invalid Entry* |